DYNAMIC ALGORITHM FOR DIMENSIONAL SUB-TUNING IN TURNING
DOI:
https://doi.org/10.17770/etr2025vol4.8423Keywords:
Mechanical engineering, dimension sub-tuning, CNC machine toolAbstract
One of the possibilities for increasing the accuracy when machining a series of parts with a single dimensional adjustment (automatic obtaining of dimensions) is to perform more frequent dimensional sub-tuning. There is a possibility to increase the accuracy of machining through dimensional sub-tuning if working with a complete set of data about the dimensions of the machined parts, and not with small current samples. This opportunity arises from the widespread introduction of computer technology for the purposes of managing the technological processes. The article examines the possibilities for determining the moment for dimensional sub-tuning by using computer analysis of information about the dimensions of the machined parts in real time.
References
Z. Driss, Mechanical Engineering Technologies and Applications Vol.1, e-book, DOI: 10.2174/97898149981851210101, 2021.
P. Leong, A Guide To Statistical Methods In Research With Cases & Applications: A Research Guidebook, Publisher: Independently published, April 6, 2021.
T. Iyengar, M. Prasad, S. Ranganatham and B. Gandhi, Computer Oriented Statistical Methods, Publisher: S Chand Publishing, 2023.
M. Chandra, Statistical Quality Control, Publisher: Taylor & Francis Inc, 2020.
S. Salapateva, “Technological research for active control in CNC turning” dissertation, Technical University – Sofia, Plovdiv, Bulgaria, 2005.
Bulgarian State Standard "Statistical Methods for Control - General Provisions", Quality Committee at the Council of Ministers of the Republic of Bulgaria, Sofia, 1986.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Silviya Salapateva, Radostina Mihova
This work is licensed under a Creative Commons Attribution 4.0 International License.