RESEARCH AND MODELING OF THE FINISHING METHOD OF CYLINDRICAL GEAR TEETH THROUGH COLD PLASTIC CALIBRATION
DOI:
https://doi.org/10.17770/etr2025vol4.8420Keywords:
calibration, gear-shaving machines, thread-rolling machines, accuracyAbstract
The operational performance of gearwheels is largely determined by the accuracy of the parameters and the quality of the working surfaces of the teeth, the requirements for which are constantly increasing. To optimize the machining conditions (increasing productivity, tool durability and the quality of the machined gearwheels), a method for finishing machining by calibration on gear-shaving and thread-rolling machines is proposed in the work. Experimental studies have been conducted to prove the operability of the proposed method. The results obtained have been analyzed and compared with gear-milled gearwheels in terms of kinematic accuracy, smoothness of operation and contact of the teeth. Regression models have been obtained for the accuracy parameters of the teeth before and after processing by calibration and subsequent heat treatment, the analysis of which shows that their size is largely determined by their input values. The results of the studies confirm the assumption of the presence of a correlation between the same accuracy parameters at the input and at the output during processing by calibration and subsequent heat treatment.
References
D. Petrova, B. Vlahova, A. Lengerov, T. Zlateva-Petkova. Improvement of Constructive-Technological Approaches Reducing Innovative Obsolescence of Industrial Technologies in the Context of Industry 4.0, Vide. Tehnologija. Resursi - Environment, Technology, Resources, Proceeding of the 14th International Scientific and Practical Conference, 2023, Volume I, pp. 180-186, Print ISSN 1691-5402, Online ISSN 2256-070X, DOI: https://doi.org/10.17770/etr2023vol1.7238 https://www.scopus.com/authid/detail.uri?authorId=56323816400.
D. Petrova, B. Vlahova, A. Lengerov, T. Zlateva-Petkova. Study of the State of Innovation Development and Obsolescence in the Republic of Bulgaria of Companies from the Mechanical Engineering Sector, Vide. Tehnologija. Resursi - Environment, Technology, Resources, Proceeding of the 14th International Scientific and Practical Conference 2023, Volume I, pp. 187-194, Print ISSN 1691-5402, Online ISSN 2256-070X, DOI: https://doi.org/10.17770/etr2023vol1.7239 https://www.scopus.com/authid/detail.uri?authorId=56323816400
N. Nikolova. Industry 4.0 - development and consequences for sustainable development of Bulgaria, 13th International Scientific and Practical Conference “Environment. Technology. Resources”, June 17-18, pp. 245-251, 2021, Academy of Technologies, Rezekne, Latvia,Volume III, ISSN 1691-5402, ISSN 2256-070X.
B. Matev, P. Kunov, Installation for modeling the process of surface plastic deformation (SPD) of gearwheel teeth. International scientific conference, VMEI – Gabrovo, 1990.
Handbook of the Machining Technologist”, part 2, State Publishing House “Technika”, Sofia, 1990.
Production of gearwheels. Handbook. Under the general editorship of Taits B.A. Moscow, Mashinostroenie Publishing House, 1990.
T. Kuzmanov, Hr. Metev. Technology of mechanical engineering, parts 2,3. Publishing house "EX-PRESS" Ltd. - Gabrovo, 2015, 2016.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Kalin Krumov, Hristo Metev
This work is licensed under a Creative Commons Attribution 4.0 International License.